ORS Quality Control
Process |
 |
Metrology Laboratory Accredited according to ISO EN 45000 standards, measures roundness, form and surface roughness vital for bearing production. Measurements for production and calibration of masters are made according to International Standards. |
 |
Chemical Laboratory pH concentration, corrosion, stability, nitride, boron, dropping point, flash point, penetration, viscosity measurements, as well as testing cutting fluids, conservation oils and greases. Spectral analysis of greases, oils, emulsions, is done to ensure bearing performance, and to protect against human health hazards. |
 |
Metallography Laboratory Fully equipped and accredited metallography laboratories inspects all incoming material. Hardness, chemical composition, microstructure, microcleanliness, and tensile strength are all tested. Inc addition, vital factors to bearing life such as heat treatment cracks are also controlled by the Metallography Lab. |
 |
Engineering Bearings are designed with the use of the most sophisticated CAD systems. Customer requirements and application factors are reviewed by Engineering and suggestions, technical information, assembly parameters are redily available. Engineering is continually researching higher performance products and manufacturing methods. |